Husqvarna Automower Solar Hybrid Technical Manual page 47

• The boundary wire runs across a long slope
(steeper than 10 %).
When Automower follows the boundary wire
across a slope (steeper than 10 %) the mower
must compensate for the slope. The mower must
stop relatively often to check the strength of the
loop signal and then follow the boundary wire at
a slower speed. The risk of the mower running
outside of the working area due to skidding
increases.
• The charging station is positioned on an island.
When there is more than 4 metres between the
charging station and the outer edge of the
boundary wire, it can take a long time for
Automower to find the charging station when it
follows the boundary wire. There is a risk of the
mower following the outer edge of the working
area 2 – 3 turns before it changes direction and
starts to follow the loop at another spot.
3.3.2 Installation of the guide wire
Check that the charging station has the best
placement.
• Placement of the charging station and where on
the boundary wire the guide wire is connected
affect the length of the guide loop, see the 1.10.2
Guide loop, page 16.
The adjoining picture shows what is considered
a guide loop.
The picture is also a good example of an ideal
position for the charging station to give the
shortest possible guide loop.
• Make the guide wire as short as possible. The
longer the guide wire, the closer the mower
follows the guide wire. If the guide wire exceeds
200 metres (700 ft), the mower may find it
difficult to follow the wire.
3. INSTALLATION
3012-670
3012-651
3012-650
English - 47