Advertisement
THE BREATHING TUBE SHROUD
A breathing tube shroud is available for the PROFLOW FH22 Hood made of
the same material as the hood fabric. The breathing tube shroud is used to
facilitate cleaning and/or decontamination of the breathing tube.
ATTACH THE BREATHING TUBE SHROUD AS FOLLOWS:
1. Thread a tie wrap through the channel at one end of the breathing tube
shroud. Orient the lock end of the tie wrap as shown in FIGURE 3. Posi-
tion the lock end close to the channel opening. Insert the end of the tie
wrap through the lock and engage one or two teeth to form a loop large
enough to fit over the breathing tube.
FIGURE 3
2. Repeat step 1 with another tie wrap in the channel at the other end of the
shroud.
3. Slide the breathing tube shroud over the end of the breathing tube and
position the first end as shown in FIGURE 4. The tie wrap should be just
below the hose coupling.
FIGURE 4
4. Pull the tie wrap snug around the breathing tube. Cut off the excess tie
wrap.
5. Position the other end of the breathing tube shroud as shown in FIG-
URE 5. The cable tie should be just above the hose coupling.
FIGURE 5
6. Pull the tie wrap snug around the breathing tube. Cut off the excess tie
wrap.
P/N 595141-01 Rev A 7/08
6
Advertisement
