Digitax F3 Plus Technical Manual page 38

Nr. Functions
255 State of taximeter for light n. 3 ON: this is the state (or states) of the taximeter in which the light number 3 should be ON.
The allowed values are:
Also combinations are allowed. In that case the values need to be summed together.
For example, to put ON light number 3 in Stopped and also in ForHire the value to program is: 64 + 128 = 192.
256 Enable light n. 4 ON in day-time? - Should it be possible for light number 4 to be ON during the day-time?
The allowed answer is either:
257 Light n. 4 must flash? - If Yes light number 4 will flash. The allowed answer is either: 0 (No: no flash) or: 1 (Yes: flash).
258 Light n. 4 must go ON in overspeed? - If Yes then light number 4 will go ON in case the actual velocity is higher than the velocity programmed in Q.200. The allowed
answer is either:
259 Light n. 4 must go on below overspeed?
263 Light n. 4 ON in this tariff-block? - With Yes light number 4 will go ON in the corrisponding tariff-block. The allowed answer is either: 0 (No: OFF) or: 1 (Yes: ON).
264 Block-number for light n. 4 ON: this is the number of the tariff-block where light number 4 should be ON. The allowed value goes from 0 (min) to 62 (max).
265 Prog-Date-number for light n. 4 ON: this is the number of the Prog-Date where light number 4 should be ON. The allowed value goes from 0 (min) to 8 (max).
266 State of taximeter for light n. 4 ON: this is the state (or states) of the taximeter in which the light number 4 should be ON.
The allowed values are:
Also combinations are allowed. In that case the values need to be summed together.
For example, to put ON light number 4 in Stopped and also in ForHire the value to program is: 64 + 128 = 192.
267 Must be Euro the default currency? - Establish default currency starting the trip
268 Disable visualization of clock on display? - Should the visualization of the clock on the (secondary) display be disabled?
The allowed answer is either:
269 Inhibit clock-time programming from panel? - Should the possibility to program the clock-time from the panel be inhibited?
The allowed answer is either:
270 Disable visualization of chronometer? - Should the visualization of the chronometer on the display be disabled?
The allowed answer is either:
271 In ForHire show text "F-HIRE" on display? - Should the text "F-HIRE" be shown on the primary display when in ForHire?
The allowed answer is either:
272 Distance is in yards ? (if not: metres) - The distance in Q.2 to Q.4 is in yards? If not then the distance is in metres.
The allowed answer is either:
273 Put ON the decimal point at pos. 2/3? Should the decimal point between the second and third position (from the right) be put ON? For example: 5.00.
The allowed answer is either:
274 Put ON the decimal point at pos. 3/4? - Should the decimal point between the third and fourth position (from the right) be put ON? For example: 5.000.
The allowed answer is either:
275 From Stopped back to Hired with key K2? - Should it be possible to go from Hired to Stopped pressing key K2?
The allowed answer is either:
276 Chronometer shown as 9959? (if not: 9-59) - Should the time of the chronometer be shown as 9959 on the secondary display? If not, it will be shown as 9-59. So,
practically the dash is sacrificed for gaining another digit of the chronometer. The allowed answer is either:
277 Chronometer shows minutes ? (if not: seconds) - Should the chronometer show minutes on the secondary display? If not, it will show seconds.
The allowed answer is either:
Show clock/year for 5 seconds with K3/K4? - If this question is enabled and key K3 is pressed then the clock will be shown on the secondary display and the date on the
278
main display for 5 seconds. With this question enabled and key K4 is pressed then the year will be shown on the main display for 5 seconds. This question is only
meaningfull if the visualization of the clock has been disabled with Q.268. The allowed answer is either: 0 (No: disabled) or: 1 (Yes: enabled).
Disable manual programming of the Euro currency?
279
Disable the Euro conversion in Hired?
280
Disable the Euro conversion in Stopped?
281
Put off displays in ForHire after time of Q.283? – If yes then in ForHire the displays will be put off after the time established in Q.283.
282
See also Q.283. The allowed answer is either:
283 Stand-by time in Hired and Stopped: in Hired and Stopped this is the time after which the taximeter will go in stand-by. In stand-by the internal functions are all active but
the display is put OFF. The taximeter is 'woken-up' by either pressing any key or by the first pulse from the transducer. The time is given in minutes with an accuracy of 1
minute. The allowed value goes from 0 (min) to 255 (max).
284 Shut-down time in ForHire: in ForHire this is the time after which the taximeter will be shut-down. In shut-down all internal functions except the clock are disactivated and
also the display is put OFF. The taximeter is 'woken-up' by either pressing the OP key or by the first pulse from the transducer. Also see Q.192. If the answer is 0 the
taximeter doesn't switch-off automatically anymore. Is this case it can only be switched-off manually by pressing in For-Hire position K2 and K4 together. The time is given in
38
The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confidential. Any disclosure, copying, distribution to third
0 (none) - 32 (Hired) - 64 (Stopped) - 128 (ForHire).
0 (No: disabled) or: 1 (Yes: enabled).
0 (No: OFF) or: 1 (Yes: ON).
from Q 260 to Q 262 available for any possible software extension
0 (none) - 32 (Hired) - 64 (Stopped) - 128 (ForHire).
0 (No: enabled) or: 1 (Yes: disabled).
0 (No: enabled) or: 1 (Yes: disabled).
0 (No: enabled) or: 1 (Yes: disabled).
0 (No: show text) or: 1 (Yes: don't show text).
0 (No: metres) or: 1 (Yes: yards).
0 (No: put OFF) or: 1 (Yes: put ON).
0 (No: put OFF) or: 1 (Yes: put ON).
0 (No: disabled) or: 1 (Yes: enabled).
0 (No: seconds) or: 1 (Yes: minutes).
0 (No) or: 1 (Yes).
LIGHT N. 4
VARIOUS FUNCTION
No=Local currency
0 (No: 9-59) or: 1 (Yes: 9959).
party is strictly prohibited.
Yes=Euro
Value
For Hire = 128
Stopped = 64
Hired = 32
None= 0
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
0 - 62
0 - 8
ForHire= 128
Stopped= 64
Hired= 32
None= 0
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
0=metres
1=yard
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
No / Yes
0 - 255
minutes
0 - 255
minutes