Page 2
The taximeter has, in its front side, 5 keys (or buttons) called: OP, K1, K2, K3, K4. The taximeter has three working modes called: FOR HIRE STOPPED HIRED The taximeter’s working modes are selectable by pressing the OP button in the following sequence: For Hire Hired Stopped...
Page 3
FIG. 1 STATIS FOR HIRE ST OPPED HIRED Night Day Mod. FARE £ k= 200 to 100000 i/km By Digitax S.r.l 62017 Portorecanati (MC) ITALY TAR. EXTRAS £ Serial Nr. 960000100 Push these keys at the same time Memory Data...
Page 4
5)Press OP button to go back to For Hire mode and to END procedure. FOR HIRE ST OPPED HIRED Night Day FIG.4 Mod. FARE £ k= 200 to 100000 i/km By Digitax S.r.l 62017 Portorecanati (MC) ITALY EXTRAS £ Serial Nr. TAR. 960000100 Push these keys at the same time...
Page 5
STATISTICAL MEMORY READING Memory Location List ML Block 1 Block 2 Trips total number idem Taximeter units total number idem Total Kilometers idem Total Kilometers in For Hire idem Total Kilometers in Hired idem Km in for For Hire with passenger on board idem Km in Over speed idem Collected Total (Fare+Extras+Tax)
No responsibility can be accepted for any loss or dam- age caused in transit, except for repair or substitution of defective parts. No other liability will be recognized by Digitax for any kind of damage or loss to person or goods.
SET TIME AND DATE Settings In order to manually programme the clock, please check that you are in For Hire position (by OP) and then press K1 and K3 at the same time. The sign “Time” appears on the main display for a few seconds and then For Hire and Stopped will fl...
Page 8
Month Hour Minutes Push Together Sets the Sets the Month Sets the Hour Sets the Minutes Press to set the Year Set the Year Press to end the programming and to confi rm data...
Need help?
Do you have a question about the F1 PLUS and is the answer not in the manual?
Questions and answers