Pre-Operational System Check - HP 85106D Manual

Pre-Operational System Check

Table 4-1 Pre-Operational System Check Table
Check
HP 8510 front/rear panel control settings
HP 8510C operating system firmware revision
Cabling and HP-IB addresses of all instruments in
the system
HP 8360 Series source language switch setting
HP 8360 Series source automated calibration
procedure (full user cal)
Service and Troubleshooting
Pre-Operational System Check
Additional Information
HP 85101 and HP 85102B power switches ON
Must be revision B.6.54 or later
See Figure 4-3 on page 4-6,
Figure 4-7 on page 4-19,
and Figure 4-8 on page 4-23 in this procedure
See Figure 4-8 on page 4-23
HP 83621/31/51 Calibration and Installation
HP 85106D mm-Wave System 4-5