If The Self-Test Fails To Run - HP 85106D Manual

Table 6-3
If the Self-test Fails to
Run
The ACTIVE LED should always remain off until the HP 85105A is
accessed by the HP 8510. Each time the test set is turned on the Port 1 and
Port 2 LEDs will light for approximately 2 seconds during the self-test, and
then turn off. To determine what part of the self-test has failed, note which
LEDs on the A4 board are lit. Refer to Table 6-3 for failure indications.
Self-Test Failure Indications
Self-Test Indication
LSN
PWON ON
Fail ROM Test OFF
Pass ROM Test OFF
Fail RAM Test OFF
Pass RAM Test OFF
If the portion of memory which contains the self-test programming is faulty,
the self-test will not run properly. The following conditions indicate that the
self-test ROMs are probably faulty.
•
all LEDs flash briefly and go off
•
all LEDs flash briefly and stay on
•
ACTIVE LED goes on too soon
HP 85105A mm-Wave Controller
A4 HP-IB LED's
Time (after turn-on)
TLK SRQ REM
ON ON ON 0 to 0.5 sec
ON ON ON ON briefly
OFFF ON ON 0.5 to 2.0 sec
OFF OFF ON
OFF OFF OFF after 2 sec
HP 85106D mm-Wave System 6-27
Self-Test Indicators