HP 85106D Manual page 33

Installing the Test-Set
Module Cable-Support
Assembly
NOTE
Getting Started
Preparing the Site
Use the cable-support assembly to support the RF, LO, and interconnect
cables of the HP 85104A test-set modules. These cables connect the test set
modules to the HP 85105A mm-wave controller.
Refer to the "Cable Support Assembly" on page 1-15 for an illustration of
the cable support assembly components. The barrel is attached to the test set
module cable assembly, the bracket and clamp block must be attached to the
barrel, then to the mm-wave controller handle. Follow the procedure below
to install the cable support assembly.
The cable support assembly orientations for port 1 and port 2 are different.
Be sure to follow the instructions for the appropriate port.
1-14 HP 85106D mm-Wave System