Heta Scan-Line 800 Series Operating And Installation Instructions

Heta Scan-Line 800 Series Operating And Installation Instructions

Hide thumbs Also See for Scan-Line 800 Series:

Advertisement

OPERATING AND INSTALLATION
INSTRUCTIONS
SCAN-LINE 800 SERIES
APPROVED FOR USE IN SMOKE CONTROL AREAS WHEN
BURNING DRY WOOD LOGS OR AUTHORISED FUELS
www.heta.dk
EN
DANISH DESIGN . DANISH QUALITY . DANISH PRODUCTION
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Scan-Line 800 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Heta Scan-Line 800 Series

  • Page 1 OPERATING AND INSTALLATION INSTRUCTIONS SCAN-LINE 800 SERIES APPROVED FOR USE IN SMOKE CONTROL AREAS WHEN BURNING DRY WOOD LOGS OR AUTHORISED FUELS www.heta.dk DANISH DESIGN . DANISH QUALITY . DANISH PRODUCTION...
  • Page 2: Installation Instructions

    The Scan-Line 800 series and the Scan- hat it is economical to use. Line 800 series with side windows have both been approved according to the...
  • Page 3: Draft Conditions

    The Scan-Line 800 series can be instal- powerful firing. The flue gas tempera- led with a horizontal straight back outlet. ture at nominal output is 272°C for the Maximum length of the pipe should be Scan-Line 800 series and 277°C for the...
  • Page 4 • Poor smoke extraction (poor draft Good draft occurs when: conditions) due to a cold chimney • The difference in temperature bet- or bad weather conditions can be ween the chimney and outdoor air compensated for by increasing the is high. airflow into the stove.
  • Page 5: Chimney Fires

    handle is in the lowest position (fig. 2), Wood kg/m Wood kg/m combustion airflow is completely closed. Beech Alder Fig. 1 Fig. 2 Scotch pine 520 Larch Maple Lime Birch Spruce Mountain Poplar pine Willow It is advised not to use very oil-conta- Open Closed ining woods like teak tree and maho-...
  • Page 6 Lighting instructions for Heta stoves 1. Place some scrunched up newspaper 2. Fully open the ”side” air control. and firelighters on the base of the stove Light the firelighters and leave the door and stack some small pieces of wood/...
  • Page 7 Refuelling A fresh supply of fuel should normally be added while there is still a good layer of hot embers. Spread the embers over the base grate, most towards the front of the stove. Lay a single layer of wood fuel corresponding to about 1.5 kg over the embers, at right angles to the stove door.
  • Page 8: Risk Of Explosion

    Risk of explosion i.e. there are no more flames because the wood fuel has been transformed into After you add new fuel, it glowing charcoal. is very important that you do not leave the stove unat Optimal combustion tended until the wood is burning con- For optimal combustion and heating, this stantly.
  • Page 9: Operational Problems

    5m3/hour/m then a outside air supply. ventilator equivalent to 550mm per kW The Heta SL800 requires a permanent output will be required (5.5kW x 550mm air vent opening of minimum 550sq mm = 3025mm MAINTENANCE Cleaning the glass The surface of the stove has been tre- ated with heat-resistant paint.
  • Page 10 GUARANTEE The model Scan-Line 800 stoves are Damage resulting from incorrect use subjected to stringent quality control Transport costs in connection with procedures both throughout the produ- repairs carried out under guarantee ction process and immediately before Installation/disassembly in connection delivery to the dealer.
  • Page 11 Connection of external air flow (fresh air) via rotating floor base Scan-Line 800 se- ries • Tap or screw to remove and de- tach the four adjusting screws in the base plate. • To mount the rotating base, follow instructions in ”Scan-Line Rota- ting Base Instructions for Use”, without tightening the central screw.
  • Page 12 Optional connection of external air flow (fresh air) Scan-Line 850 on column Rear connection through co- lumn • Slide the plate (supplied with the stove) between the connector and the stove base plate. If required, attach 3 x 8 mm self-adhesive glass door seal on the end of the air connector.
  • Page 13 Emptying the ash pan, fig. 5-8 Lubricate Ash pan Grease not included. 2 x Grease Changing to back smoke outlet Fig. 9-16...
  • Page 14 Cleaning after sweeping the chimney andreplacing the stones. Fig 17-23 - Scan-Line 800 standard...
  • Page 15 Cleaning after sweeping the chimney andreplacing the stones. Fig 24-30 - Scan-Line 800 side windows WALL-MOUNTED STOVES Fig. 31 Special instructions for Scan-Line 850/850 M/side 125 mm/130 mm side windows windows When mounting the stove to a wall/ shelf, etc., please: 1.
  • Page 16 Secretary of State or Minister in the acquire an ”unauthorised fuel” for use devolved administrations. within a smoke control area unless The Scan-Line 800 series have been it is used in an ”exempt” appliance recommended as suitable for use in (”exempted” from the controls which...

Table of Contents