Halogen Lamp Removal; Measuring The Temperature In The Middle Of The Oven Cavity - Miele H 408 BM Series Technical Information

Technical Information
4.2

Halogen Lamp Removal

1. Remove the bulb cover retaining screw at the top of the oven cavity.
2. Remove the bulb cover.
3. Pull the bulb out to remove.
Note:
Never touch a halogen bulb with bare fingers. When inserting a glass halogen
bulb, always hold with a soft cloth.
4.3

Measuring the Temperature in the Middle of the Oven Cavity

Note:
Measure according to EN 60350.
The heater elements must generate their maximum output power at
nominal voltage, or else interference caused by a faulty temperature
regulator is possible.
The specified times were obtained with a supply voltage of 230 volts.
Temperature variations were originally specified in K (Kelvin).
Note:
Required tools:
Electronic thermometer, mat. no. 05595760
Sensor, mat. no. 07121370
Magnetic holder, mat. no. 05054650
Sensor socket, mat. no. 07132940
Oven rack
1. Check the voltage of the switched-off and switched-on heating system.
2. Hook the sensor (Figure 031-2, Item 1) in the magnetic holder (Figure
031-2, Item 3).
3. Slide a rack into the empty oven (first level from the bottom). The sensor
must be located in the geometric center of the oven (Figure 031-2, Item 1).
4. Close the oven door.
5. Set up the Quick Heatup 250°C mode.
6. A temperature increase of 155 degrees must be reached in 5.5 minutes
maximum.
50
H 408x BM