Removing The Door Handle; Removing The Door Inner Pane; Removing The Door, Complete With Hinges - Miele H 408 BM Series Technical Information

H 408x BM
Note:
When removing the outer pane, take care not to bend the metal hooks on the
bottom of the door. Push them back into position if needed before re-installing
the door.
4. Pull the outer pane up and remove it.
5. Remove the wing nut at the top of the middle pane (Figure 020-1, Item 3).
6. Pull the middle pane up and remove it.
Note:
When re-installing the middle pane, make sure that the beveled corner is at
the lower left (see Figure 020-1, Item 4).
Note:
When re-installing the outer pane, set the bottom retaining brackets onto the
pins. With both hands, firmly push on the outer pane until you hear it engage
on both sides with a click.
4.3

Removing the Door Handle

1. Remove the door outer pane (refer to Section 020-4.2).
2. Place the outer pane flat onto a work surface, inner side facing up.
3. Remove the handle retaining screws.
4. Remove the handle.
4.4

Removing the Door Inner Pane

Note:
The door inner pane is not replaceable on its own. If it is broken, then the
entire door must be replaced. See Section 020-4.5.
4.5

Removing the Door, Complete with Hinges

1. Remove the appliance from its cabinet (refer to Section 011-4.3).
2. Turn the appliance on its side.
3. Remove the hinge retaining screws on the bottom of the appliance.
Note: When the door is pulled out, the hinges will snap shut.
4. Leading with the bottom edge, remove the door (with hinges) from the appliance.
Danger!
Adjust the door switches after installation (see Section 011-4.9).
After installation is completed, as a matter of standard practice, check the
oven for a tight seal with a microwave leak detector, paying particular attention
to the door and the housing edges.
45
Technical Information