Fl.net Module Setup Procedures; Startup Procedure - Hitachi FL.NET User Manual

5 USER GUIDE

5.2 FL.NET Module Setup Procedures

5.2.1 Startup procedure

The startup procedure for the FL.NET module is described below:
Start
Mount the module.
Set MAIN/SUB switch.
Start up LPU.
Startup S10V FL.NET SYSTEM.
Set the FL.NET
module IP address.
Auto reset LPU.
Set up the FL.NET module.
End
① Switch OFF the LPU unit and then install the FL.NET
module.
② Set the MAIN/SUB selector switch on the FL.NET
module (See "3.3 Setting the MAIN/SUB Selector
Switch.").
③ Switch ON the LPU unit.
④ Connect the LPU unit to the Windows® personal
computer via an RS-232C interface cable or Ethernet.
Start the setup tool named "S10V FL.NET SYSTEM"
(See "5.4 Installing and Starting up the System.").
⑤ Set the IP address and subnet mask for the FL.NET
module. (For IP address and subnet mask setup
procedures, see item (1), "IP address/subnet setup
precautions," on the next page.)
⑥ Set up the FL.NET module link parameter (See "5.3.1
Link parameter setup procedure.").
5-28