Hitachi FL.NET User Manual page 133

5 USER GUIDE
[Function]
A task abort, release, or queue execution request can be issued to a remote node.
When a response message is received, the task control execution result (log value) is written
at the CPMS macro execution result storage address.
Specify the parameters as indicated below:
<To execute a task abort>
CPMS macro parameter count = 2
CPMS macro parameter [0] = 1
CPMS macro parameter [2] = task number (1 to 255)
<To execute a task release>
CPMS macro parameter count = 2
CPMS macro parameter [0] = 2
CPMS macro parameter [1] = task number (1 to 255)
<To execute a task queue>
CPMS macro parameter count = 3
CPMS macro parameter [0] = 3
CPMS macro parameter [1] = task number (1 to 255)
CPMS macro parameter [2] = task number (0 to 32)
Note: Task numbers 230 to 255 are used by the system. So they are not started even if
specified.
Exercise due care when using the above transparent message request. If the
task number is erroneously specified, the CPU or CMU of the remote node
(S10V) may become inoperative.
NOTICE
5-78