Hitachi FL.NET User Manual page 14

(chapter 5, page 5-65)
The FL.NET module does not support the server feature for a stop directive. If a
stop request is issued to the FL.NET module, it returns a response to indicate
that it does not support the stop directive.
(chapter 5, page 5-67)
The FL.NET module does not support the server feature for a run directive. If a
run request is issued to the FL.NET module, it returns a response to indicate that
it does not support the run directive.
(chapter 5, page 5-78)
Exercise due care when using the above transparent message request. If the
task number is erroneously specified, the CPU or CMU of the remote node
(S10V) may become inoperative.
(chapter 5, page 5-90)
When an offset size is specified for a specific node number, it is stored in
memory until the FL.NET module is turned OFF or reset. Note, however, that
the user cannot reference the offset setting within the FL.NET module after
completion of offset setup. The offset setting must be managed by the user.
The above feature is designed for use in cases where the available memory
space of the S10V is insufficient. It is recommended that you do not use the
feature when the memory space of the S10V is adequate.
When the address limit of common memory area 1 or 2 is exceeded by the
application of an offset, the resulting excess portion of address data will not
transfer to the S10V memory. Exercise care not to exceed the limits of the
common memory areas.
NOTICE
NOTICE
NOTICE
NOTICE
S-11