B) Using The Magnetic Trigger; Setting The Battery Indicator - PowerBox Systems GEMINI II Instruction Manual

b) Using the magnetic trigger

Hold the magnetic trigger close to the switching zone (depression) in the case
- see illus-tration above - and wait a moment until you hear a signal from the inte-
gral buzzer. A pair of internal Hall sensors pass on the signal to the two micro-pro-
cessors. These are only switched on or off if the signal strength and signal dura-
tion are as specified.
If you install the unit in a concealed location, make certain that you hear the doub-
le-beep which indicates that both switching circuits have been switched on or off.
The audible signal which accompanies the power-on procedure differs in pitch
from the power-off signal.

4. SETTING THE BATTERY INDICATOR

If you intend to use a 5S NiCd or NiMH battery, or a 2S LiFePo battery, you must
set the voltage monitor correctly, otherwise the LED will constantly flash red. Ho-
wever, this setting has no influence at all on the actual switching process or the
stabilising circuits.
This setting can only be changed using the SensorSwitch. This is the procedure
for setting the various battery types:
- Connect both batteries, and switch on the Gemini II.
- Hold the Set button pressed in, and observe the LEDs.
- The LEDs first light up orange, then go out again after a few moments.
- Pause: keep the button pressed in.
- The LEDs flash green once, and the unit emits a single beep. If you release the
6 PowerBox-Systems − World Leaders in RC Power Supply Systems