Connecting The Batteries And The Sensorswitch; Switching On And Off; A) Using The Sensorswitch - PowerBox Systems GEMINI II Instruction Manual

2. CONNECTING THE BATTERIES AND THE SENSORSWITCH

Connect your batteries to the MPX high-current inputs, taking care to maintain
correct polarity.
CAUTION: connecting the batteries with reversed polarity will instantly destroy
the two regulators in the Gemini II. If this should happen, the regulator monitor
causes the two LEDs to flash alternately red and green to indicate the fault.
Connect the SensorSwitch to the socket on the side of the case; the connector
cannot be inserted the wrong way round.

3. SWITCHING ON AND OFF

a) Using the SensorSwitch

The unit is switched on by holding the button on the SensorSwitch pressed in un-
til the LEDs light up orange. Release the button for a moment, then press it briefly
a second time. This action confirms the switching process.
The method of switching off is identical: hold the button pressed in until the LEDs
light up orange, then release the button and press it again briefly to confirm the
action.
The unit emits a double-beep to confirm that it is switched on or off; the audible
signal which accompanies the power-on procedure differs in pitch from the po-
wer-off signal.
www.powerbox-systems.com 5