Mounting The Front Panel - Hanseatic HGTI4582C10T7736ES User Manual

11. Screw the dishwasher to the kitchen unit.
– If you have granite worktops, remove
the internal side cover caps (e) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (j) with the cover
caps.
– For all other worktops, screw the
mounting bracket (f) firmly to the work
surface.

Mounting the front panel

A front panel must only be used for the model
with the article number14440547.
You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(g)
3. A gap of 5 mm to 25 mm can be offset
with the 5 trim strips supplied (g). Remove
the required number of trim strip from the
block. To do so, move the trim strip vigor-
ously but without using tools.
4. If you only need one trim strip,
saw off the four feet that stick
out, clamp the trim strip under
the control panel and secure
it using both countersunk
screws (l).
Continue with Step 7.
Installation, connection and initial commissioning
5. If you need more than one trim strip,
6. If you
7. Pull apart the two pairs of Velcro straps (h).
Remove the protective film from the same
type of Velcro strap.
8. With the protective film removed,
turn the lower trim strip and push it onto
the other trim strips. This hides the feet
and makes the surfaces flat.
– need two trim strips, secure these using
both countersunk screws (l).
– need three trim strips, secure these
using both countersunk screws (m).
– need four to five trim strips, secure these
using both countersunk screws (n).
(h)
affix the hook-and-loop strips to the mid-
dle of the recessed areas on the dish-
washer door.
Page EN-33
(h)
(h)