Page EN-34
Installation, connection and initial commissioning
9. Cut the positions of the Velcro straps out
of the drilling template.
10. Cut the number of trim strips used off the
drilling template.
11. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
12. Transfer the drill holes from the drill tem-
plate to the front panel.
13. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
14. Remove the protective films from the
other Velcro straps and stick the Velcro
straps to the front panel using the drilling
template.
15. Fix the front panel to the dishwasher
door using the Velcro straps (h), hold it
firmly and carefully open the door.
16. Remove the 4 screws from the inside of
the door. Screw the front panel in place
at these positions using the 4 enclosed
(h)
screws (k).
(k)
(h)
The front panel has been successfully mounted.
(k)