Advertisement
User manual / Bedienungsanleitung
2.2 Universal tonearm w ithout VTA-Lifter:
Universal
Pic. 7:
tonearm without
Mounting the aluminum clamping ring on a non-Clearaudio turntable:
To install the aluminum clamping ring on the turntable chassis, you will need to drill the required
holes. Please refer to the drilling template shown below (Picture 8) for the measurements to mark
the exact drilling holes.
Please be informed, that this draw ing is not suitable for use as a mounting tool.
Use a 3.3 mm HSS drill bit, then cut an M4 thread into each hole using an appropriate tap cutting
tool. If the turntable chassis material is not suitable for cutting threads, please use a 4.5 mm HSS
drill bit to drill the holes through the material. In this case use standard bolts and nuts to fix the
arm base.
Please note:
This drilling template is only for
Universal
pivot to spindle for
Pic. 8: Mounting the aluminum clamping ring on a non-Clearaudio turntable
8
VTA-Lifter
9 inch tonearms. You will find the the correct
Universal
12 inch in the technical data on page 13.
© clearaudio electronic GmbH, 2018/ 11
Advertisement
