Valance Installation; Testing The Shade - Levolor Roman Shades Series Installation Manual

INSTALLATION | OPERATION
INSTALLING THE VALANCE
Be sure to complete motorization set-up before installing the valance.
Install Valance
• Hook the top of the valance over the top
lip of the headrail.
• Carefully press the valance down and
back against the headrail until the valance
clips into place.
Attach Valance Returns (Outside Mount Only)
• Fold the valance returns around the end of
the headrail and firmly press into place so
that the hook-and-loop strips engage.

TESTING THE SHADE

Testing the shade with the manual control button will allow you to ensure that the
motor and power source are working correctly.
IMPORTANT: When raising the shade for the first time, observe how the fabric
stacks. It should stack evenly. Immediately stop the shade if the bottom rail is
not level or the shade starts to rub against either window jamb. "See "Adjusting
Alignment and Folds (if necessary)" on page 23.".
• Press the manual control button on the bottom of
the end cap to test operation. If the shade does not
operate, see "Troubleshooting" on pages 24-25.
— Press the button to alternately lower, stop, and raise the shade.
Further Operation and Programming Information
Remote Operation
For information regarding operation and programming of
the remote control, refer to your Remote Control Guide.
22
Battery-Powered Motorized Operating System
Valance
Manual
Control
Front of
Button
Shade
ALL
1 2 3
4 5 6
Roman Shades
Remote Control Guide
Guía de persianas romanas
con control remoto