Levolor Roman Shades Series Installation Manual page 20

INSTALLATION
OUTSIDE MOUNT (OM)
STEP 6: IF USING A SATELLITE BATTERY PACK...
MOUNTING THE SATELLITE BATTERY PACK
• Decide where you want to mount the wall mount bracket.
A satellite battery pack may be mounted in any orientation.
• Mark the screw holes.
• Drill the screw holes using a
• Remove the backing from the double-sided tape. Press the bracket into place.
• Attach the bracket using the screws provided.
• Position the battery pack so the power
cable is easily connected to the socket.
• Snap the battery pack into the bracket.
• Replace the cover with the slot aligned
to the socket in the battery pack.
• Plug the power cable from the
shade into the extension cable.
• Plug the other end of the extension cable into the
socket in the battery pack.
• Secure the extension cable using wire retainers (not provided)
• Install the battery wand cover with the slot aligned to the socket
in the battery wand.
• Plug the power cable from the shade into the extension cable.
• Plug the other end of the extension cable into the socket in the battery wand.
• Secure the power supply cable using wire retainers (not supplied). If hiding the
cable behind the shade, make sure it does not impede the operation of the shade.
CAUTION: Make sure all extension cables are secured. Young children
!
can STRANGLE in cords. They can also wrap cords around their necks
and STRANGLE. Electrical shock and/or a fire hazard may occur, if not
properly installed.
IMPORTANT: Be sure the cable does not become pinched by the battery wand
clip during installation. Damage or overheating of components could result.
20
Battery-Powered Motorized Operating System
⁄ " drill bit.
3
32
Socket
Slot
Socket
Socket
Socket
Slot
Battery Wand Cover
Socket
Battery Wand Cover
Wall Mount Bracket
Wall Mount Bracket
Battery Pack Cover
Extension
Cable
Power Cable Power Cable
from Shade from Shading