Outside Mount - Levolor Roman Shades Series Installation Manual

INSTALLATION
OUTSIDE MOUNT (OM)
Bracket
Bracket
STEP 1: MARKING THE BRACKET LOCATIONS
NOTE: The rear of the brackets must be flush against a flat mounting surface.
Do NOT mount brackets on curved molding.
•
Center the headrail over the window opening at the desired height.
•
Use a pencil to lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark
the headrail end points over the window opening.
•
Mark approximately 1 - 2" in from each end of headrail for the installation
bracket locations.
— Allow a minimum of
top of the window molding.
•
With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 1 screw per bracket.
•
Use a level to ensure all brackets are aligned.
•
If more than two installation brackets come with your order, space additional bracket(s)
evenly between the two end brackets, no more than 30" apart, mark drill hole locations.
— If more than two installation brackets came with your order, space them
evenly between the two end brackets and mark their location. Allow a minimum
of 18" from the motor side of the headrail, and 15" between installation brackets
to accommodate the standard battery pack. See page
pack installation. Mount into wood whenever possible.
14
Battery-Powered Motorized Operating System
⁄ in. between the bottom of the installation bracket and the
1
4
18 for standard battery