Polaris RIDE COMMAND User Manual page 11

This equipment complies with part 15 of the Federal Communications
These requirements are intended to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the
party responsible for compliance could void the user's authority to operate the
This vehicle contains the following radio equipment or components that contain
radio equipment:
COMPONENT
9200 Series Display
Hereby, Polaris Industries Inc. declares that the above radio equipment is in
compliance with EU Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
internet address:
https://www.polaris.com/en-us/radio-conformity/
CAUTION
Commission (FCC) rules.
occur in a particular installation.
following measures:
equipment.
COMPONENT ID
RC7
INTRODUCTION
MANUFACTURER
Polaris Industries Inc.
9