Table of Contents
Advertisement
Standard dimensions for
determining the width of the
collector array
Number of collectors
Width [m] installation on end
Installation of the support frame
Combination
screw
M8x20 coach bolt
Washer
nut M8
Washer
nut M8
M8x20
coach bolt
Washer
nut M8
0.2 m
Installation on end:
NB
- Are all gaskets in place?
- Maintain the necessary
clearance
- Align all threaded fittings
- Counterhold with a second
open-ended spanner.
(max. torque 20 Nm.)
Extension of the mounting rail
from 4 collectors
3062815_0110
16. Flat roof installation
NB: No consideration has been given to the installation location or the pipe
connections.
1
–
0.9 m
1.13 m
1. Create an adequate substructure (e.g. concrete ties) (on site).
2. Secure the support triangles on the substructure.
Possibly secure the support triangles with guy wires (on site).
3. Secure the mounting rails at the bottom / top with M8x20 coach bolts to the
support triangle.
4. Insert the collector with the grub screws first into the lower mounting rail according
to the diagram and initially secure it by hand with the M8 washer nut.
5. Push the combination screws M8x20 through the top mounting rail and
initially tighten by hand into the collector.
6. Fit additional collectors likewise.
7. Secure the fittings for the flow and return. Check gaskets.
8. Tighten all screws and nuts to secure the collector.
If more than 3 collectors are fitted, extend the mounting rails in accordance
with the diagram.
Mounting rail,
e.g. for 3 collectors
2
3
4
2.23
3.36
4.49
5.62
1.13 m
Mounting rail
joining set
3 coach bolts M8 x 25 with washer nuts M8
5
6
7
8
6.75
7.88
9.01
Top mounting rail
Diagonal
brace
0.2 m
Additional: 1.13 m
Mounting rail, e.g. for
2 additional collectors
9
10
10.14 11.27
Guy ropes
(on site)
Substructure
37
Advertisement
Table of Contents
