Table of Contents
Advertisement
Installation of the
intermediate panels
Flashing tape
Create a fold
26
14. Roof integration, slate roof
Intermediate panel
1. Push in the intermediate panels as per diagram. If this should jam during the
installation, correct the collector position. Then bend the tabs over at the top of the
intermediate panels to prevent them from sliding through.
2. Tighten all screws and nuts to secure the collector.
3. Pull off all the protective foil from the flashing tape and affix it to the tiles. Create a
fold at the ends of the flashing tape bases on the left and right.
Tabs
Intermediate panels
Fold
3062815_0110
Advertisement
Table of Contents
Need help?
Do you have a question about the CFK-1 and is the answer not in the manual?