How To Set A User Parameter And The User Parameter Table - Yamato DP-6900 Service Manual

3-3. How to set a user parameter and the user parameter table

The parameters of the DP-6900 are divided into 3 groups, "User Parameters," "Dealer Parameters," and
"System Parameters." In test mode you can change any of the parameters. In normal mode where a weight is
displayed, you can change user parameters only.
(1) User parameters
With the user parameters, the users can change the functions of the instrument according to their
specifications.
◊ How to set a user parameter
Press and

The panel shows the user parameter #01 and its setting.
Use the following keys when you set user parameters.
: Switches to the next
parameter.
(TIPS)

 Hold down
when the parameter is #01 switches the parameter to #P4).
 When the setting value is flashing, press
then flashes. Hold down
Press again to enter a setting value.
(IMPORTANT)
When you have changed a setting, be sure to press

turning off the power.
Unless you switch to the next parameter, any changes you made to the setting will be lost.
User parameter table
No. Item
#01 Checkweighing function
Parameter only for DP6900
#03 LED lighting timing
(parameter for multi-function)
Parameter only for DP6900
Operation
at the same time.
: Increases the
parameter setting by 1
and press to return to the previous parameter (Pressing these keys
or at this point to move the parameter number fast forward.
Setting
Description of options
value
0: Disable the checkweighing function
1: Simplified checkweighing function
Inspection checkweighing function
2: (The upper and lower limits are set using the measured weight of a
sample as the middle value.)
0:
Disable LED
1:
LED ON upon underweight
2:
LED ON upon proper weight
3: LED ON upon overweight
4:
LED ON upon underweight and flashes upon overweight
to shift the focus to the parameter number, which
to switch to the next parameter before
8
Display
: Decreases the
parameter setting by 1.