Screw Tightening Torques; Assembly; Pre-Assembly Measures - SCHUNK VERO-S WDM-5X Assembly And Operating Manual

4

Screw tightening torques

Screw tightening torques for mounting the base module WDM-5X-80-BM 80 onto the
machine table (screw quality 10.9)
Screw size
Tightening torques M
5

Assembly

5.1
Check that the delivery is complete and that there is no transport damage.
Assembly, dismantling and modification work on the workpiece direct clamping module may
only be carried out by specialist personnel.
Disconnect the power supply lines and ensure that there is no residual energy in the
system before performing assembly, modification, maintenance, or adjustment work.
Until the workpiece direct clamping module is assembled, access to the side attachment
screw of the clamping units must be ensured, particularly when the clamping pallets are
clamped.
Before installing, check whether the drive pistons and the attachment screw can be easily
reached for opening and for clamping and loosening the interface connection on the
workpiece direct clamping systems respectively.
Assembly
M10
(Nm) 52
A

Pre-assembly measures

CAUTION
Risk of injury due to sharp edges and rough or slippery surfaces.
• Wear personal protective equipment, particularly protective
gloves.
WARNING
Risk of injury due to falling when transporting the workpiece
direct clamping module.
• Transport with care.
M12 M16
92 224
01.00|WDM 80 |de
17