Mounting And Beam Alignment - Omron Sti F3SJ-AM P Series Quick Installation Manual

Function Selection

5-5. Mounting and Beam Alignment

1. Attach the top/bottom brackets.
Step1
Check
Fit in the slot of the convex block
position
Step2
Top/bottom
Mount
mounting
bracket (2)
Step3
Align
beams
Tightening with torque exceeding the recommended value too much may lead to a failure.
2. Attach the intermediate mounting brackets (2) and (3).
Mounting
screw
(M3x10)
For mounting positions of the intermediate mounting brackets (2) and (3), refer to 5-4 E dimensions.
7
Mounting/Beam Alignment
Mounting screw
(M5x20)
(Recommended tightening torque: 2.3N•m)
Top/bottom
mounting
bracket (3)
Mounting screw
(M3x8)
Intermediate
mounting
bracket (2)
Intermediate
mounting
bracket (3)
Pre-Operation Checklist /
Maintenance Checklists
Tighten
lightly
Attach the bracket so that the tab of the bracket
in the dotted circle should be on the back end.
Top/bottom mounting
bracket (1)
Tighten lightly
Insert the tab in the slot
F3SJ-AM
Quick Installation Manual