Page 1
● Complies with IEC standards and North American stan- matic reset of output. ● The emitter lens and receiver lens are equipped with heat- dards (received IEC61496-1, -2, and UL/CSA certification). Can be used as a safety guard for satisfaction of OSHA ers for worry-free operation even in environments where requirements for on-site labor safety in North America.
Page 2
Sensor clamp for 42-mm dia. column stand F39-LSP Note: Wiring is based on a built-in terminal block. Please purchase a 4-mm to 7-mm (dia.) cable separately. Safety Relay Unit For controlling the outputs we recommend to use safety relay units G9SA or G9SB...
Page 3
Auto start mode, start interlock mode, and start/restart interlock mode can all be selected using a switch in the Operating mode receiver. PNP transistor outputs x 2 outputs, load current 250 mA or less (residual voltage 1 V or less) (excluding voltage Control output drop due to cable extension), Light ON...
Page 4
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. E17E-EN-01 In the interest of product improvement, specifications are subject to change without notice. G-76 Safety Sensors / Components...