Page 2
Caution! WARNING: Please use this product as instructed. Misuse may cause injury or death. DO NOT use while driving Caution for Battery Use • Do not pierce or puncture the battery DO NOT expose to water or wet with sharp objects surfaces.
Table of Contents Chapter 1: S1 at a Glance Keystone Adjustment S1 Introduction Chapter 4: Technical Details Keypad Troubleshooting What’s in the Box Specifications Chapter 2: Getting Started Notes Powering On / Off Focus Adjustment / Throw Ratio Connecting a Nintendo Switch...
Keypad Brightness Settings Advanced Settings Increase Volume Decrease Volume Keystone adjustment The keypad is used to navigate through the onboard menu system, adjust the volume and adjust keystone.
After a few seconds, the unit should turn off fully. Charging the projector To charge your S1, use the power adapter supplied in the box. The LED indicator on the left side of the unit will light up red to show the projector is receiving power.
Connecting to a Nintendo Switch Step 1: Power on the S1 by holding the power button down for at least three seconds Step 2: Power on the Nintendo Switch by holding the power button down for at least three seconds Step 3: Dock the Nintendo Switch into the S1.
Chapter 3 Projector Settings Access the different settings available on the projector easily by tapping the keypad. Tap on the Gear Icon to Tap on the Lightbulb Icon access the Advanced to access the Brightess Settings Settings...
• Boost Mode - The brightest mode. • Charge Device - This option allows the S1 to act as a powerbank for the Nin- tendo Switch NOTE: Boost Mode is only available when AC adapter is plugged into power.
After tapping on the Gear icon, as mentioned on Page 8, the Advanced Set- tings will pop-up Within the settings menu there are four submenus that allow you to customize your S1 to the settings you want: Picture • Picture Mode •...
(red to blue). Aspect Ratio* • Changes the aspect ratio of the picture. Choose among Auto, 4:3 and 16:9 Noise Reduction • This setting is not supported on the S1 Brightness Mode • Choose among Eco, Standard, Boost** and Charge Mode Projection Direction *Caution: Some pictures may be cut off •...
Sound Settings Sound Mode • Changes the sound mode depend- ing on what is currently playing. Balance • Adjusts the balance of the sound, from left to right. Auto Volume • Not functional on the S1.
Time Settings Sleep Timer • Sets a timer for the projector goes to sleep. Auto Sleep • Sets auto sleep function where projector will turn off when not in use or if there is no signal.
Advanced Settings OSD Language • Changes the language of the device. Options include English, Spanish, Chinese, German, French Restore Factory Default • Restores the projector to factory settings.
Keystone Adjustments What is Keystoning? “Keystoning” occurs when a projector is aligned non-perpendicularly to a screen, or when the projection screen has an angled surface. The image that results from one of these misalignments will look trapezoidal rather than square. Digital Keystone Adjustments By adding a special, selectable algorithm to the scaling, some new projectors are able to alter the image before it reaches the projection lens.
Page 19
Keystone Adjustments FAQ How to Correct Keystone • If the image looks trapezoidal with the base larger (as pictured right), press the “up” button on the directional pad on the top of the P300 Neo until the keystone effect corrects and the picture turns into a square projection.
Chapter 4 Technical Details Troubleshooting THE PROJECTOR DOES NOT TURN ON Possible Causes Solution There is no power Check to ensure the power outlet source is good. Check the Power Adapter to ensure a proper con- nection with the wall outlet as well as the projector. Confirm that the unit is charged and has enough power.
Page 23
Please direct all customer service inquiries to: AAXA Technologies, Inc. 17691 Mitchell N., Unit B Irvine, CA 92614 (714) 957-1999 info@aaxatech.com...