2" Hitch Receiver Mount; Hitch Mount (Hpm-C) - Task Force Tips HEMISPHERE Instructions For Installation, Operation And Maintenance

4.2 2" HITCH RECEIVER MOUNT

The 2" backbone for the I-beam clamp is sized to fit into any standard 2" x 2" Class III or Class IV hitch receiver.
1) Remove the 2 jaws from the I-beam assembly.
2) Slide the backbone into the hitch receiver and secure
with a standard 5/8" (16mm) hitch pin. Use a cotter pin
or some other retention device to retain the hitch pin.
3) Install the cross-pin mount on the backbone
and secure with a cross-pin.
WARNING

4.3 HITCH MOUNT (HPM-C)

The 2" Hitch Mount can be installed on a standard 2" class III trailer hitch. The mount can be inverted for access to the hitch ball for
towing, provided there is sufficient clearance from the ground and other objects while towing.
1) Remove the hitch ball, nut, and lock washer from
the hitch tongue.
2) Insert the hitch mount washer into the mount.
Place the mount flush against the hitch tongue
on the opposite side of the desired position of
the ball.
3) Insert the hitch ball through the tongue and
hitch mount washer.
4) Fasten the lock washer and nut to the hitch ball.
5) Slide the assembly into the hitch and secure with the
hitch pin and cotter pin.
Using the hitch mount for anything other than mounting a monitor is a misuse of this product.
NOTICE
Never attempt to tow or pull with the hitch mount.
©Copyright Task Force Tips LLC 2013-2020
Figure 2.11 I-Beam Clamp Installation Step 4
Unsecured monitors will move suddenly when flow is initiated and could cause injury or death.
Cross pin must be installed and secured before charging hose and while flowing monitor.
Hitch Mount Assembly and Installation
2
Hitch Pin
Cotter Pin
Figure 4.3
13
3
Hitch Ball with
1" Threaded Stud
(Standard for 2" Hitches)
Standard 2" Hitch
Hitch Mount
Hitch Mount Washer
1" Lock Washer
1" Nut
LIX-740 July 21, 2020 Rev08