®
Eaton
setUPS
Firmware upgrade procedure
7. Confirmation
The following screen appears which reminds you that UPS output is OFF (but load still
powered) during the upgrade, select "Yes" to continue
8. Upgrade process
The UPS emits a beep and transfers into Boot loader mode. The firmware will then be
erased and then rewritten into the UPS.
During the flash process, the status led (AC line, Battery, Bypass & Fault) on the UPS
cycle, a progress bar is displayed on LCD and a beep is emitted every 10s :
Eaton®setUPS_9PX_1-1_1to3k_firmware_upgrade_rev_02
Page 9/13