Memory Function; Adjustable Settings - ADC Adtemp 433 Instructions For Use Manual

6. MEMORY FUNCTION

The unit retains the last 50 readings. The newest reading will occupy memory cell 1,
the oldest, memory cell 50.
To recall previous readings:
1. With the power off, press the up "▲" or down "▼" button to view the history of
measured values. The display will indicate whether the reading was a body or
surface temperature measurement.
2. An empty memory cell shows "---°C" or "---°F".
Note: Once 50 measurements are in memory each new measurement will overwrite
the oldest.
To delete readings from memory:
1. With the power on, press and hold the up "▲" or down "▼" button multifunction
key until the display shows "CLR." The device will sound a long beep, which means
that all stored temperature readings have been cleared.
Note: All readings (body and surface) will be cleared when deleting readings from memory.

7. ADJUSTABLE SETTINGS

The Adtemp 433 has three adjustable settings:
F1 Temperature Scale F/C
1. With the instrument on, press the SET button until the display reads F1.
2. Press the up "▲" or down "▼" button to move between Celsius and Fahrenheit scale.
3. Press the SET button to confirm the new setting.
Please note: The factory default is Fahrenheit.
F2 Fever-Alert Threshold
The fever-alert threshold is the temperature at which the backlit display color
turns red. The default fever alert is 100.6°F (38.1°C).
To change the threshold:
1. With the instrument on, press the SET button twice (until the display reads F2).
2. Press the down "▼" button to decrease by 0.2° F. Press the up "▲" button to
increase 0.2° F.
3. Press the SET button to save.
9