Guidance And Manufacturer's Declaration - ADC Adtemp 433 Instructions For Use Manual

13. GUIDANCE AND MANUFACTURER'S DECLARATION

Guidance and manufacture's declaration - electromagnetic emission
The Infrared Body Thermometer is intended for use in the electromagnetic environment specified below.
The customer or the user of the Infrared Body Thermometer should assure that it is used in such an environment.
Anti-interference detection
Electrostatic discharge (ESD)
IEC 61000-4-2
Surge
IEC 61000-4-5
Surge
IEC 61000-4-5
Voltage dips
IEC 61000-4-11
Voltage interruption
IEC 61000-4-11
Power frequency (5 0 H z / 6 0 H z)
magnetic field IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
Guidance and manufacture's declaration - electromagnetic emission
The Infrared Body Thermometer is intended for use in the electromagnetic environment specified below.
The customer of the user of the Infrared Body Thermometer should assure that it is used in such an environment.
Immunity Test
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mo-
bile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with ac-
curacy. To access the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey
should be considered. If the measured field strength in the location in which the Non Contact Infrared Body Ther-
mometer is used exceeds the applicable RF compliance level above, the Non Contact Infrared Body Thermometer
should be observed to verify normal operation. If abnormal performance is observed, additional measures may be
necessary, such as re-orienting or relocating the Non Contact Infrared Body Thermometer.
b) Over the frequency range 150 kHz to 80 MHz, Field strength should be less than 3 V/m.
IEC 60601 test level
Contact: +8 KV
Air: +2,+4,+8,+15 KV
Input power ports: +0.5, +1.0 KV
Signal input/output:+2.0 KV
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
0.5 cycles for > 95%
(sync angle (degrees):0, 45, 90,
135, 180,225, 270, 315)
1 cycles for >95% UT
(sync angle (degrees):0)
25 (50Hz)/30 (60Hz) cycles for
30% U T (sync angle (degrees):0)
250 (50Hz)/300 (60Hz) cycles for
>95% UT (sync angle (degrees):0)
30A/m
IEC 60601 test level
3 Vrms
150 kHz to 80 MHz
15
Compliance level
Contact: +8 KV
Air: +2,+4,+8,+15 KV
Not applicable
Not applicable
Not applicable
30A/m
Compliance level
Not applicable
Professional healthcare environment:
3 V/m home
Healthcare environment:
10 Vm 80 MHz to 2700 MHz