Adjustable Windshield System
Triumph Rocket III
Please read this entire manual before proceeding with installation.
What is in the box:
(1) Set of preassembled MadStad adjustable windshield brackets
(2) Pre-assembled fork-mount brackets
(2) M8 x 50mm bolts
(2) M8 aluminum spacers
(2) M10 x 50mm bolts
(2) M10 aluminum spacers
(4) M5 Philips screws
(4) M5 plastic washers
(4) soft rubber washers
The MadStad quick-release windshield (and optional fly screen) clip onto compact
brackets that stay attached to the forks. Pages 2 and 3 show how to attach these brackets.
Windshield Installation
Once bracket installation is complete, the windshield attaches to the brackets with four
Phillips truss screws, plastic flat washers and rubber washers as shown below. You can prep
the shield first by inserting each screw and washers into each windshield hole from the front,
and pushing the rubber washer on from the back to hold the screw in place.
Once all four screws are on the shield, set it against the brackets and run the screws into the
rubber well nuts. The rubber well nuts are flexible and shield holes are oversized so you can
nudge the shield around to align the
screws with the holes properly. Get two
of the screws started on one side of the
bike to keep them from coming out,
then move over to the other two. When
all four are in then tighten them all
snugly but DO NOT OVERTIGHTEN!
Too much torque and you could
damage the well nuts.