MadStad Engineering MadStad Manual
Bmw r1200gs 2004 - 2012 adjustable windshield mount
Hide thumbs
Also See for MadStad:
- Manual (12 pages) ,
- Installation instruction (2 pages) ,
- Manual (8 pages)
Advertisement
Quick Links
Adjustable Windshield Mount
BMW R1200GS (2004 - 2012)
Please read this entire manual before proceeding with installation.
What is in the box:
(1) MadStad Brackets set
(2) MadStad side plates
(4) M6 x 16 screws
(4) M6 flat washers
(4) M6 lock nuts
(4) M8 x 35mm screws
(4) M8 flat washers
(4) M8 lock nuts
(4) M5 T-Screws
(4) 3/8L rubber washers
(4) soft rubber washers
These MadStad adjustable windshield brackets are designed to bolt to the metal
factory brackets that are on the left and right side of the factory windshield. The
factory windshield must first be removed as well as any tubular steel support.
You will not be using any of these pieces, only the hardware provide in this kit.
Advertisement
Related Manuals for MadStad Engineering MadStad
Summary of Contents for MadStad Engineering MadStad
- Page 1 (4) 3/8L rubber washers (4) soft rubber washers These MadStad adjustable windshield brackets are designed to bolt to the metal factory brackets that are on the left and right side of the factory windshield. The factory windshield must first be removed as well as any tubular steel support.
-
Page 2: Installation Overview
INSTALLATION OVERVIEW The MadStad brackets attach to the stock windshield mounting holes. Remove the stock windshield and leave both factory mounting arms in the same position. – Attach the MadStad brackets to the factory windshield BRACKETS mounting points. Use the M6 x 12 screws, lock washers and flat washers that came with the kit. -
Page 3: Windshield Installation
Then lay the shield over the brackets and insert the protruding screws into the rubber well nuts on the brackets. (The stock shield and MadStad shields use a different pair of well nuts which is why there are three per side.) It’s probably easiest to start with the two holes on one side (left or right) then do... - Page 5 Adjusting the RoboKnob Brackets The knob screws release the brackets allowing the windshield to slide and tilt. These knob screws must always be tightened securely before riding. DO NOT attempt to adjust the brackets while riding! You must come to a complete stop before making adjustments.
- Page 6 PIVOT SCREWS The MadStad mount has a pivot screw on each set of brackets, located near the center of the bottom bracket. A nylon lock nut keeps the screw snugly in place, yet allows the brackets to slide back and forth.
-
Page 7: Returns And Warranty
Disclaimer Neither MadStad Engineering nor its owners shall be liable for any damages, consequential or inconsequential, resulting from the use of our products. Installation of any of our products constitutes acceptance of these terms. It is the responsibility of the user to make sure all fasteners are... - Page 8 MadStad Engineering, Inc. 20721 US Highway 301 Dade City, FL 33523 U.S.A. Phone: 352-608-4069 Fax: 352-608-4195 Web Site: http://www.madstad.com Email: support@madstad.com Thank you for your support, and ride safely! April 13, 2018...