Table of Contents
Advertisement
4
1
3
Take out the screw (1) and
remove the spring (3) with
washer (2).
Carefully remove the rope
rotor (4).
Caution:
The rewind spring is installed in the
rope rotor. It may pop out and uncoil
if the rope rotor is not removed very
carefully.
– Take the rewind spring out of the
rope rotor.
Note:
The replacement spring comes
ready for installation and is held
together by a wire retainer. It should
be lubricated with a few drops of
STIHL special lubricant before
installation - see 11.
Series 4141 Powerhead
1
2
2
Fit rewind spring (1) in the rope
rotor so that the anchor loop (2)
engages the recess (3). The wire
retainer slips off during
installation.
Caution:
The rewind spring may pop out and
uncoil during installation.
If the rewind spring has popped out,
see "Standard Repairs, Trouble-
shooting" handbook.
1
Fit rope rotor in starter cover and
engage inner spring loop (1) in
slot (2) at the same time.
1
3
3
Fit spring (3) with washer (2) and
tighten down screw (1) to 1.1 Nm
(0.8 lbf.ft).
– Tension the rewind spring - see
7.4.2.
– Install the rewind starter - see
7.2.
2
2
29
Advertisement
Table of Contents
