Table of Contents
Advertisement
3
1
2
Thread other end of rope through
the "ElastoStart" grip (1) and
spring (2). Secure with a simple
overhand knot.
Pull rope with spring back into the
"ElastoStart" grip. Fit cap (3).
– Tension the rewind spring - see
7.4.2.
– Install the rewind starter - see
7.2.
Series 4141 Powerhead
8
Throttle Control
8.1
Throttle Trigger/Interlock Lever
Take out the screw.
1
Use screwdriver (1)
5910 890 2301 (1) to remove
screws.
– Separate the two halves of the
handle.
1
2
Lift the interlock lever (1) slightly
and turn it to one side until the
torsion spring (2) is relaxed.
Pull the interlock lever and
torsion spring off the peg.
1
2
Take the throttle trigger (1) with
torsion spring (2) and throttle
cable (3) off the peg.
Disconnect throttle cable from
trigger.
Reassemble in the reverse
sequence.
Pay attention to the following points
during installation.
Attach the throttle cable, then
position torsion spring as shown
and push its long arm into the
slot.
3
31
Advertisement
Table of Contents
