Start - MAKER MADE M2 Complete Beginner Assembly Manual

Automated cutting machine kit
Hide thumbs Also See for M2:
Table of Contents

Advertisement

M2 ASSEMBLY GUIDE

14. START:

Before you cut, raise the Z-Height 3mm above your print surface (so it doesn't start touching
your material). Put on safety goggles, set your router RPM to the recommended cut speed
for the material, manually turn on your router so your bit is spinning, and click "Run" to begin
cutting out your project! We recommend running the first cut with the router off to ensure
everything is running properly, please finish reading this section before beginning.
Drew'd Note: When your M2 is cutting for the first time, be close to the power source to stop all opperation
if something goes awry. After your first test cut, you should measure and compare the real values of your
square cut to the values of your Gcode for scaling, described in step 12. Be sure that you set easel's cut path
around the outside of your square, so you can have the correct measurement from the inside edge to inside
edge.
40
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license.
Last Updated 11.09.2020
Version 1.14

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M2 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

M2 cnc

Table of Contents