On/Off Button; Mode Button; Fan Button - Tadiran Telecom SMVH09A-2A1B1NA Service Manual

ON/OFF button

Press this button can turn on or turn off the air conditioner.

MODE button

Press this button to select your required operation mode.
When selecting auto mode, air conditioner will operate automatically according to ex-factory setting. Set temperature can't be
adjusted and will not be displayed as well. Press "FAN" button can adjust fan speed. Press "
fan blowing angle.
After selecting cool mode, air conditioner will operate under cool mode. Press "+" or "- " button to adjust set temperature. Press
"FAN" button to adjust fan speed. Press "
When selecting dry mode, the air conditioner operates at fan1 under dry mode. Under dry mode, fan speed can't be adjusted.
Press" " or " " button to adjust fan blowing angle.
When selecting fan mode, the air conditioner will only blow fan, no cooling and no heating. Press "FAN" button to adjust fan
speed. Press " " or "
When selecting heating mode, the air conditioner operates under heat mode. Press "+" or " - "
button to adjust set temperature. Press "FAN" button to adjust fan speed. Press "
angle. (Cooling only unit won't receive heating mode signal. If setting heat mode with remote controller, press ON/OFF button
can't start up the unit).
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5 minutes to blow air (actual delay time is
depend on indoor ambient temperature).
● Set temperature range from remote controller: 16~31℃ ; Fan speed: auto, fan1, fan2 , fan3 , fan4, fan5, infinte speed.

FAN button

Pressing this button can set fan speed circularly as: auto (AUTO), fan1(
fan4 ( ), fan5 (
Note:
● Under AUTO speed, air conditioner will select proper fan speed automatically according to ex-factory setting.
● Fan speed under dry mode is fan1.
● After entering the infinite fan speed mode, curses can adjust the fan speed according to the button"+" or"-".
button
Press this button turn on or turn off up & down swing function.The remote controller defaults to static swing condition.
Press "MODE" button and "
swing.
In static swing condition, pressing button, the swing angle of up & down louver changes as below:
Note:
When selecting " " with remote controller, it's auto swing. Horizontal louver of air conditioner will swing up&down automatically
at the maximum angle.
When selecting " ,
will stop at that position as shown by the icon to swing.
Auto Cool
" or "
" button to adjust fan blowing angle.
), infinite fan.
AUTO
infinite fan
" button at the same time at remote controller OFF to switch between simple swing and static
No display
, , , " with remote controller,it's the fixed position swing. Horizontal louver of air conditioner
Dry Fan Heat
" button to adjust fan blowing angle.
), fan2 (
fan1 fan2 fan3
fan5 fan4
Function and Control
" or " " button can adjust
" or " " button to adjust fan blowing
) , fan3 ( ) ,
11