Operating Your Sauna - Maxxus MX-J206-01 Instruction Manual

17. Enter the sauna and remove the protective covering from the TEMPERATURE SENSOR. Situate the
TEMPERATURE SENSOR so that it is vertical, pointing downward.
Installation Completed.
Operating the Sauna
NOTE: Before the sauna is turned on, remove plastic protective covering from the CONTROL PANELS. Please
check and confirm that the connections to the POWER SUPPLY, HEAT EMITTERS, CD/RADIO, and
TEMPERATURE SENSOR are connected properly. The power supply voltage and frequency must match the
requested voltage and frequency of the sauna (120VAC 15AMP Dedicated Circuit or 120VAC
20AMP Dedicated Circuit).
Since many materials absorb the infrared rays, minimal clothing is recommended for maximum effect. The
infrared sauna emitters are designed to heat you and not necessarily the air inside the sauna. It is not a hot box
like a traditional sauna. The temperature gauge is a guide for your safet y. It is recommended that you drink
water before, during, and after sauna use to prevent dehydration since body fluids will be lost through
perspiration. It is not recommended to shower after use since the pores in your skin will be open and could
possibly absorb anything in the water.
1. Plug the sauna into the outlet receptacle.
2. Press the POWER button once. The POWER light will come on, the TIME DISPLAY will show 90 (minutes), the
TEMPERATURE DISPLAY will show 66 (degrees Celsius), and the control panel will flash.
3. Press the up/down arrows under the TIME DISPLAY to adjust the amount of time you want the sauna to remain
on. Press the C/F button to choose between Celsius and Fahrenheit. Press the up/down arrows under the
TEMPERATURE DISPLAY to adjust the temperature setting. Once you have set these adjustments to the
FIG 19
11