Otto Bock Motus Instructions For Use Manual page 67

Mounting (Fig. ÂÅ)
 Place the protective rim band over the valve. Then push the valve through the rim. Screw on
the valve nut, if there is one. The rim band can then be easily applied.
 Ensure that all spoke ends are covered.
Tires (Fig. 59)
 Beginning behind the valve, place the lower side of the tire over the edge of the wheel rim.
Pump the tube with a small amount of air until it assumes its round shape. Then insert it into
the tire.
 Check the inner tube for folds. If folds are present, release some air. Now you can easily
install the upper side of the tire starting across from the valve, using both hands and working
towards the valve.
)MÄ@SHMF
 Check around the tire on both sides to ensure that the tube is not clamped between the edge
of the tire and the rim.
 Push the valve back slightly and then pull it out again such that the tire is well-seated in the
valve area.
 Iv<O@ OC@ ODM@ PIODG DO ><I NODGG =@ KM@NN@? @<NDGT RDOC TJPM OCPH={ A OC@ >JIOMJG GDI@ JI =JOC ND?@N
of the tire is equally distanced to the rim, the tire sits centrally. If the tire does not sit centrally,
G@O JPO NJH@ <DM <I? M@<GDBI OC@ ODM@{ C@I DIv<O@ OC@ ODM@ OJ OC@ KM@NNPM@ DI?D><O@? JI OC@ ND?@
wall and tighten the dust cap.
ÂÅ 59
67