Figure 51 Advanced: Routing; Table 31 Advanced: Routing - ZyXEL Communications ZyXEL NBG-415N User Manual

Figure 51 Advanced: Routing

The following table describes the labels in this screen.

Table 31 Advanced: Routing

LABEL
Add Route
Enable
Destination IP
Netmask
Gateway
Interface
Metric
Save
Clear
Routes List
Enable
Destination IP
Netmask
Gateway
Chapter 7 Advanced
DESCRIPTION
Select this option to activate this setting.
This field is not applicable for pre-defined routes.
Enter the destination IP address in dotted decimal notation.
Enter the subnet mask.
Enter the IP address of the gateway device for the selected interface below.
Select an interface to which you want to apply the setting.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
Click Save to save the settings.
Click Clear to start configuring this part of the screen again.
Select this option to activate this rule. Clear this check box to disable this rule
without deleting it.
This field displays the destination IP address.
This field displays the subnet mask for the destination IP address above.
This field displays the IP address of the gateway device.
ZyXEL NBG-415N User's Guide
82