KYMCO K-XCT 125i Service Manual page 219

10
. A.C. GENERATOR/STARTER CLUTCH
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Apply oil to the starter reduction gear shaft.
Install the starter reduction gear and shaft to
the right crankcase.
Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
＊
Before installation, check and make sure
that the inside the flywheel is not
contaminated.
Starter Driven Gear
Shaft Reduction Gear
Key Groove
K-XCT 125i
Flywheel
10-8