KYMCO K-XCT 125i Service Manual page 242

12
. COOLING SYSTEM
In
Install the dowel pins and a new gasket and
then install the water pump assembly to the
right crankcase cover.
Tighten five bolts to secure the water pump
assembly.
＊
When installing the water pump
assembly, aligning the groove on the
water pump shaft with the tab on the oil
pump shaft.
WATER PUMP/IMPELLER
INSTALLATION
When the mechanical seal is replaced, a
new seal washer must be installed to the
impeller.
Seal Washer (Porcelain)
K-XCT 125i
Water Pump Assembly
Mechanical Seal
Impeller
12-14