KYMCO K-XCT 125i Service Manual page 7

1. GENERAL INFORMATION
 After operation, terminal caps shall be
installed securely.
 When taking out the connector, the lock on
the connector shall be released before
operation.
 Hold the connector body when connecting
or disconnecting it.
 Do not pull the connector wire.
 Check if any connector terminal is bending,
protruding or loose.
 The
connector
completely.
 If the double connector has a lock, lock
it at the correct position.
 Check if there is any loose wire.
Confirm
Capacity
shall be inserted
 Before connecting a terminal, check for
damaged terminal cover or loose negative
terminal.
 Check the double connector cover for
proper coverage and installation.
 Insert the terminal completely.
 Check the terminal cover for proper
coverage.
 Do not make the terminal cover opening
face up.
 Secure wire harnesses to the frame with
their respective
designated locations.
Tighten the bands so that only the
insulated surfaces
harnesses.
 After clamping, check each wire to make
sure it is secure.
K-XCT 125i
wire bands at the
contact the wire
1-4