ZyXEL Communications P-2608HWL-Dx Series User Manual page 101

Table 27 WAN More Connections > Modify (continued)
LABEL
Multiplexing
Virtual Circuit ID
VPI
VCI
IP Address
Subnet Mask
(ENET ENCAP
encapsulation
only)
Gateway IP
address
(ENET ENCAP
encapsulation
only)
Connection
(PPPoA and
PPPoE
encapsulation
only)
Nailed-Up
Connection
Connect on
Demand
Max Idle Timeout
NAT
None
SUA Only
Back
Apply
Cancel
Advanced Setup
Chapter 7 WAN Setup
DESCRIPTION
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. Refer to the appendix for more information.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management
of ATM traffic). Enter the VCI assigned to you.
This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is
not fixed; the ISP assigns you a different one each time you connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic IP address;
otherwise select Static IP Address and type your ISP assigned IP address in the
IP Address field below.
Enter a subnet mask in dotted decimal notation.
Refer to the appendix to calculate a subnet mask If you are implementing
subnetting.
You must specify a gateway IP address (supplied by your ISP) when you select
ENET ENCAP in the Encapsulation field
Select Nailed-Up Connection when you want your connection up all the time. The
ZyXEL Device will try to bring up the connection automatically if it is disconnected.
Select Connect on Demand when you don't want the connection up all the time
and specify an idle time-out in the Max Idle Timeout field.
Specify an idle time-out in the Max Idle Timeout field when you select Connect on
Demand. The default setting is 0, which means the Internet session will not timeout.
Use this section to activate NAT for this connection.
Select this if you don't want this WAN connection to use NAT.
Select this to use Single User Account NAT settings, then click Edit Detail to
configure your settings. See
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Click this button to display the Advanced Setup screen and edit more details of
your additional WAN connections. See
information on this screen.
P-2608HWL-Dx Series User's Guide
Section 10.1 on page 139
Section 7.5.1 on page 97
for more details.
for more
101