Replacing The Fuel Hose; Vibration Damping System - Husqvarna T540 XP Workshop Manual

NOTE!
Fluted pliers may not be used with the fuel
hose. They can cause material damage
resulting in damage to the fuel hose.

7.22 Replacing the fuel hose

1
The fuel hose is moulded (see Figure 72) and can
only be removed from outside of the fuel tank.
2
Pull out the fuel hose from the tank unit and unsnap
the fuel filter. See "Replacing the fuel filter" in
Figure 69.
3
Loosen the fuel hose from the carburettor and
remove it from the tank unit.
4
When assembling, make sure that the fuel hose
is fitted into the groove as outlined in Figure 73.
Remove the fuel hose from the tank and fit the
fuel filter.

7.23 Vibration damping system

Dismantling
1. Dismantle the following parts:
• Clutch cover
• Saw chain and bar.
2. Dismantle the springs as outlined in Figures 74,
75 and 76.
Cleaning and checking
Clean and inspect all parts.
Assembly
1. Assemble the springs as shown in figures 73,
74 and 75.
2. Assemble the following parts:
• Saw chain and guide bar.
• Clutch cover
Fig 72
Fig 73
Fig 74
Fig 75
Fig 76
Repair instructions
53
English –