Replacing The Fuel Fi Lter; Replacing The Fuel Hose/Return Hose; Replacing The Fuel Pump; Replacing The Fuel Hose - Husqvarna T435 Workshop Manual

7.18 Replacing the fuel fi lter
NOTE!
Fluted pliers may not be used with the fuel
hose. They can cause material damage
resulting in damage to the fuel hose.
1
When replacing the fuel fi lter, the old fuel fi lter must
be taken out of the tank unit using special tool 502
50 83-01.
2
Pull out the fuel hose A from the tank unit so you
can remove fi lter B.
3
Fit the new fuel fi lter B and press the
fuel hose A back into place.
7.19 Replacing the suction hose/return
hose
1
Dismantle the tank unit, see chapter "Dismantling
the throttle" (fi rst 4 fi gures). Use pliers with a shrin-
kable tube to loosen return and suction hose, see
fi gure 67.
2
Use a fl at screwdriver to snap the fuel pump loose,
see fi gure 67.
3
Split the suction hose C at the shaft. Replace
hoses if necessary, see fi gure 68.

7.20 Replacing the fuel pump

Dismantle the fuel pump, see chapter "Replacing
the suction hose/return hose" (fi rst 2 items).
Press the new fuel pump into place. Fit the suction
hose C and return hose D as shown in fi gure 68.

7.21 Replacing the fuel hose

1
Loosen the grommet. Pull off the fuel hose E. Loo-
sen the fuel fi lter and thread on the new hose onto
the fi lter and through the grommet.
Fig 66
Fig 67
Fig 68
Fig 69
Repair instructions
47
English –