Replacing The Handle Insert - Husqvarna T540 XP Workshop Manual

Safety equipment

6.11 Replacing the handle insert

To make the upper handle suit different hand sizes,
the chain saw is supplied with three different han-
dle insert sizes - M, L and XL. The L size is fitted
when the chain saw is delivered.
1
Release the chain brake by moving the kickback
guard backwards. Loosen the bar nut and remove
the clutch cover, saw chain and bar.
2
Loosen the four screws holding the handle insert.
Slide the kickback guard backward as outlined in
Figure 32 to access the front screw.
3
Loosen the handle insert and slide the stop switch
off its holder as outlined in Figure 33.
4
Fit the handle insert and make sure that no cables
are pinched. Rescrew the four screws and press
down the stop switch in its holder. See Figure 34.
5
Fit the guide bar, the saw chain and the clutch
cover.
26
– English
Fig 32
Fig 33
Fig 34