Replacing The Fuel Filter; Replacing The Fuel Hose Return Hose; Replacing The Fuel Pump - Husqvarna 545 Workshop Manual

Repair Instructions
7.18 Replacing the fuel filter
NOTE!
Fluted pliers may not be used with the fuel
hose. They can cause material damage
resulting in damage to the fuel hose.
1
When replacing the fuel filter, the old fuel filter must
be taken out of the tank unit using special tool
502 50 83-01.
2
Pull out fuel hose from the tank unit and pull
away the filter A. See figure 58.
3
Fit the new fuel filter A and press the
fuel hose back into place.
7.19 Replacing the fuel hose/return hose
The fuel hose is moulded and can only be removed
from outside of the fuel tank.
Use suitable pliers with a smooth cutting face and
loosen the hose from the fuel tank. See figure
58. Replace the return hose when required. Tight-
en the fuel hose on the filter side with your fingers.
7.20 Replacing the fuel pump (Purge)
Dismantle
1. ismantle the cylinder cover and the air filter.
2. Loosen suction hose C and return hose from
the fuel pump. See figure 59.
3. Snap off the fuel pump from the filter holder.
Assembling
1. Snap the fuel pump in place in the filter holder.
See figure 59.
2. Fit the return and suction hose on the fuel
pump.
3. Assemble the air filter and cylinder cover.
46
- English
Fig 58
Fig 59